Filter
Top Products
2-3
Inserting and Connecting the Battery
In accordance with APC’s interpretation of Department of Transportation
regulations, APC ships this device with the internal battery pack disconnected. The
front bezel of the unit is also not attached to the unit when it is shipped.
This procedure is for connecting the battery when the front bezel has been
prematurely installed onto the chassis. Perform the following steps to connect the
internal battery pack:
1. Grasp the front panel at the sides, as shown in Figure 4, and pull the front bezel
from the unit.
2. Remove the battery retaining bar.
Figure 4. Front Bezel Removal
3. Push the battery wire connector into the hole located to the left of the battery
pack, as shown in Figure 5. Ensure that the battery wire connector is pushed into
the hole, and securely connected by gently pulling on the wire to ensure it is
attached to the connector.