Filter
Top Products
2-1
Chapter
2
Installation
This chapter contains the following procedures:
• Removing the Battery Pack
• Installing the Unit
• Inserting and Connecting the Battery
• Powering On and Connecting Equipment
• Performing the System Test
• Status and Informational Screens
• Connecting the Components
• S20BLK Setup Using Front Panel Controls
Removing the Battery Pack
1. Remove the battery retaining bar.
2. Pull the battery straight back.
3. Press in the retaining tabs to allow the battery to come out completely.
Warning: The S20BLK weighs approximately 60 pounds, and we recommend
that two people lift the unit. If you remove the battery, as described
in the previous procedure, it will make lifting and positioning the unit
much easier. Lift the unit carefully by firmly grasping both sides of
the unit in the middle. Failure to comply may result in personal
injury and/or damage to the equipment.