Filter
Top Products
iv
Class B Labeling and Instruction Manual Requirements
Devices subject to Certification must be labeled with a Federal Communica-
tions Commission (FCC) Identifier. Devices subject to Verification or Certifica-
tion must be labeled with the following compliance statement:
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
In addition, for a Class B digital device or peripheral, the instructions furnished
the user shall include the following or similar statement, placed in a prominent
location in the text of the manual:
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the CC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used in accor-
dance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced audio TV technician
for help.
If shielded cables or other specialized accessories are necessary for the unit to
achieve compliance, a statement similar to the following should be added:
Shielded cables must be used with this unit to ensure compli-
ance with the Class B FCC limits
!