Filter
Top Products
2-10
SOURCE: XXXXXXX; EST. RUNTIME: XHRS Screen
This screen, shown previously in Figure 19, indicates which type of source the unit is
deriving power from (UTILITY, BATTERY, or STANDBY). It also displays the
EST. RUNTIME (in hours) based on the power source, and connected equipment
LOAD. In Standby, the unit does not provide an output to the rear panel outlets.
Note: Whenever the S20BLK is connected to utility power, the electronics inside
of each unit are active. If the front panel Power Switch is turned off, the
unit goes into standby mode, and shuts off power to the rear-panel
outlets, but the display remains active.
Figure 19. SOURCE: XXXXXXX; EST. RUNTIME: XHRS Screen
Firmware Version: XXXXXXX Screen
This screen, shown in Figure 20, provides information about the version of firmware
that is loaded in the unit.
Always have the firmware version available any time you contact APC
Technical Support. You should also have the model and serial numbers.
Figure 20. Firmware Version: XXXXXXX Screen
Note: The humidity reading above is displayed only when the optional
temperature/humidity probe is connected to the unit. Otherwise, only the
FIRMWARE VERSION is displayed.
Environmental Temperature Screen
This screen, shown in Figure 21, displays room temperature in both Centigrade and
in Fahrenheit when the temperature probe is connected to the unit.
Figure 21. Env. Temperature Screen
SOURCE: UTILITY
EST.RUNTIME: 2HRS
FW VERSION: 750.G1.D
R. HUMIDITY: 25.60% RH
ENV. TEMPERATURE:
27.25C 80.9F