Filter
Top Products
Firmware Pages and Descriptions
60
TPI-PRO Total Presentation Interface - Pro Edition
Protected Setup Page Elements (Cont.)
System Recovery Allows you to either reset the TPI-PRO to factory default settings and/or wipe
out all existing touch panel pages:
• The Reset System Settings button allows a user to wipe out all current
configuration parameters on the TPI-PRO (such as IP Addresses, Device
Number assignments, Passwords, and other presets).
- Pressing this button launches a confirmation dialog box (FIG. 44) which
asks you to confirm your selection.
- This dialog box is configured with a delay timer that does not enable the
YES button for 5 seconds. This delay provides an additional amount of time
for the user to confirm his decision.
• The Remove User Pages button allows you remove all current TPD4 touch
panel pages currently on the TPI-PRO (including the pre-installed AMX Demo
pages).
- Pressing this button launches a Confirmation dialog box (FIG. 44) which
asks you to confirm your selection.
- This dialog box is configured with a delay timer that does not enable the
YES button for 5 seconds. This delay provides an additional amount of time
for the user to confirm their decision.
Reboot Pressing this on-screen button causes the TPI-PRO to restart after saving any
changes.
Keyboard Layout Use the Keyboard Layout UP/DN buttons to select the type of keyboard you
want to use.
Serial Port Baud Rate Use the Baud Rate UP/DN buttons to alter the baud rate for the front serial port.
The range is from 1200 - 115200.
• Default is 38400.
FIG. 44 Protected Setup page-System Recovery confirmation dialog box
FIG. 45 Button/slider Function Show example
You have a wait time of 5 seconds
before the YES option is enabled.
Slider
Button
Channel Code
Number
3,132
2,8 3,50
Channel Port
Level Port
Address
Port
Address Code
Number
Channel Code
Number
7,10
Channel Port
4,9
1,8
Channel Code
Number
Level Port
Channel Code
Number
Address
Port
Address Code
Number