Filter
Top Products
Overview
3
TPI-PRO Total Presentation Interface - Pro Edition
TPI-PRO Specifications
The following table lists the specifications for the TPI-PRO-4 and TPI-PRO-2. Note that the primary
difference between the TPI-PRO-4 and TPI-PRO-2 is in the number of inputs. In terms of functionality
and specifications, they are otherwise identical. Therefore, the specifications listed below apply to both
versions, unless specifically noted.
TPI-PRO Specifications
Power Requirements: • Constant current draw: 2.6 A @ 12 VDC
• The PSN6.5 Power Supply (FG423-40 - not included) is recommended, to
accommodate all possible configurations and respective power draws.
Memory: • 256 MB SDRAM
• 256 MB disk memory
• See the Other AMX Equipment: section on page 6 for component upgrade
information.
Supported Video
Resolutions:
Input Composite Video and S-Video:
•NTSC M/J
• NTSC 4.43
• PAL B/D/I/G/H
•PAL 60
•PAL M
•PAL N
•PAL Nc
• SECAM B/D/G/K/L
Input Component Video:
• NTSC 480i, 480p
• PAL 576i, 576p, 720p, 1080i, 1080p
Supported Audio Sample
Rates:
48000Hz, 44100Hz, 32000Hz, 24000Hz, 22050Hz, 16000Hz, 12000Hz,
11025Hz, and 8000Hz.
Front Panel Components:
Power switch/LED Toggles the unit off and on.
• Light Off: Power to the unit is either not plugged in, below approximately
10VDC, above approximately 19VDC, or cross-wired.
• Constant Green: Power to the unit is within nominal voltage limits (between
10VDC and 19VDC, approximately), the unit is on, and all internal power
supplies are operating normally.
• Constant Yellow: Power to the unit is within nominal voltage limits (between
10VDC and 19VDC, approximately) and the unit has been turned off by
pressing the power switch for more than two seconds.
• Flashing Yellow: Power to the unit is within nominal voltage limits (between
10VDC and 19VDC, approximately), but one or more of the internal power
supplies are not operating correctly. The unit needs to be serviced. Contact
AMX Technical Support for further instructions.
USB Type-A Host ports 2 USB ports that can be used for a keyboard, mouse, external storage unit, or
USB-capable touch panel interface.
• USB 2.0 support is required for all USB devices.
• Do not use a USB hub to connect multiple USB devices to the TPI-PRO.
Serial (Programming) port DB9 connector (male) connects to a DB9 serial port on a PC, for serial
communication.
Status LED • Constant ON: No communication with the NetLinx Master
• Blinking: In communication with the NetLinx Master