Anritsu S331D Network Router User Manual


 
266) VBW Setting (Frequency in Hz)
267) VBW Setting (Frequency in Hz)
268) VBW Setting (Frequency in Hz) (lowest byte)
269) OCC BW Method (0b if % of power, 1b = dB down)
270) OCC BW % Value
23
(highest byte)
271) OCC BW % Value
272) OCC BW % Value
273) OCC BW % Value (lowest byte)
274) OCC BW dBc
24
(highest byte)
275) OCC BW dBc
276) OCC BW dBc
277) OCC BW dBc (lowest byte)
278) Attenuation
25
(highest byte)
279) Attenuation
280) Attenuation
281) Attenuation (lowest byte)
282-297)Antenna Name(16 bytes in ASCII)
298) Status Byte 1: ( 0b = Off , 1b = On)
(LSB) bit 0 : Marker 1 On/Off
bit 1 : Marker 2 On/Off
bit 2 : Marker 3 On/Off
bit 3 : Marker 4 On/Off
bit 4 : Marker 5 On/Off
bit 5 : Marker 6 On/Off
bits 6-7 : Not Used
299) Status Byte 2: ( 0b = Off , 1b = On)
(LSB) bit 0 : Not Used
bit 1 : Marker 2 Delta On/Off
bit 2 : Marker 3 Delta On/Off
bit 3 : Marker 4 Delta On/Off
bits 4-7: Not Used
298) Status Byte 3: (0b = Off, 1b = On)
(LSB) bit 0 : Antenna Factor Correction On/Off
bits 1-2 : Detection Alg (00b = pos. peak 01b = average 10b = neg. peak)
bits 3-4 : Amplitude Units (00b = dBm 01b = dBV 10b = dBmV 11b = dBuV)
bit 5 : Channel Power On/Off
bit 6 : Adjacent Channel Power On/Off
bit 7 : Not Used
299) Status Byte 4
26
(0b = Off/Beep if data is BELOW line, 1b = On/Beep if data is ABOVE line)
(LSB) bit 0 : Limit Type (0b = Single, 1b = Multiple)
bit 1 : Not Used
bit 2 : Single Limit On/Off
bit 3 : Single Limit Beep Level ABOVE/BELOW
bit 4 : Multiple Limit Upper Segment 1 Status On/Off
bit 5 : Multiple Limit Upper Segment 1 Beep Level ABOVE/BELOW
27
bit 6 : Multiple Limit Upper Segment 2 Status On/Off
bit 7 : Multiple Limit Upper Segment 2 Beep Level ABOVE/BELOW
Site Master PM 19
23 % value is 0-99
24 dBc value 0 – 120 dBc
25 Value sent as ( value in dB * 1000 )
26 For bits 2 and 0, 00=no limit, 10=single limit, 01=multiple limit, 11=multiple limit.
27 Upper limits always trigger an error beep if data is ABOVE the limit segment, for example, this bit is always 1b.