Filter
Top Products
316) Impedance Loss
247
(higher byte)
317) Impedance Loss (lower byte)
318) Frequency Scale Factor
248
(higher byte)
319) Frequency Scale Factor (lower byte)
320) Frequency Range Minimum
249
(highest byte)
321) Frequency Range Minimum
322) Frequency Range Minimum
323) Frequency Range Minimum (lowest byte)
324) Frequency Range Maximum
250
(highest byte)
325) Frequency Range Maximum
326) Frequency Range Maximum
327) Frequency Range Maximum (lowest byte)
328) Linked Trace Number (1-200)
329) Status Byte 9 (0b=Off, 1b=On)
(LSB) bit 0 : C/I Measurement On/Off
bits 1-3 : C/I Carrier Trace/Signal Type
251
bits 4-7 : Not Used
330) C/I Calculated Power
252
(Carrier or Interference - NB FHSS
253
) (highest byte)
331) C/I Calculated Power (Carrier or Interference - NB FHSS) (lowest byte)
332) C/I Calculated Power (Carrier or Interference - NB FHSS) (highest byte)
333) C/I Calculated Power (Carrier or Interference - NB FHSS) (lowest byte)
334) C/I Calculated Power
254
(Interference - WB FHSS
255
) (highest byte)
335) C/I Calculated Power (Interference - WB FHSS) (lowest byte)
336) C/I Calculated Power (Interference - WB FHSS) (highest byte)
337) C/I Calculated Power (Interference - WB FHSS) (lowest byte)
338) C/I Calculated Power
256
(Interference - Broadband
257
) (highest byte)
339) C/I Calculated Power (Interference - Broadband) (lowest byte)
340) C/I Calculated Power (Interference - Broadband) (highest byte)
341) C/I Calculated Power (Interference - Broadband) (lowest byte)
342-400) Not Used
401-2004) Sweep Data
(401 points * 4 bytes/point = 1604 bytes)
4 bytes for each data point
1. dBm
258
(highest byte)
2. dBm
Site Master PM 69
247 Value sent as (value in dB * 1000), valid values are 0 to 20 dB
248 In number of Hz
249 Scaled by Frequency Scale Factor (bytes 318-319)
250 Scaled by Frequency Scale Factor (bytes 318-319)
251 000b = NB FHSS, 001b = Carrier - WB FHSS, 010b = Carrier - Broadband, 111b = Interference
252 Value sent as (value in dBm * 1000) + 270,000
253 If Status Byte 9, bits 1-3 equal 111b, then value will be calculated power for the interference trace as a NB FHSS
signal. Otherwise, these bytes represent the calculated carrier power.
254 Value sent as (value in dBm * 1000) + 270,000
255 If Status Byte 9, bits 1-3 equal 111b, then value will be calculated power for the interference trace as a WB FHSS
signal. Otherwise, these bytes should be ignored.
256 Value sent as (value in dBm * 1000) + 270,000
257 If Status Byte 9, bits 1-3 equal 111b, then value will be calculated power for the interference trace as a Broadband
signal. Otherwise, these bytes should be ignored.
258 Value sent as (Value in dBm * 1000 ) + 270,000