Filter
Top Products
9Shut down the PC by clicking Shut Down PC in the PC Setup control panel.
10 Shut down the Macintosh, wait ten seconds, and start up the Macintosh again.
You need to shut down the Macintosh and start it up again to make sure that
the network software is installed properly.
Configuring the built-in TCP/IP stack for PPP (modem) in Windows 95
The following instructions assume that this is the first time you are installing
the Point-to-Point (PPP) software and no previous networking software has
been installed.
Using a modem connected to the Macintosh serial port
Note: The following example describes connecting a Macintosh modem to
the Macintosh modem port and then configuring it to be COM1 in the PC
environment. A modem can be connected to either the Macintosh modem
port or printer port and can be configured to COM1 or COM2 in the PC
environment.
1With your computer turned off, connect a modem to the modem port on the back of
your computer.
2 Start up the Mac OS.
3 Open the PC Setup control panel.
146
Appendix D