Filter
Top Products
Removing the card
3Grasp the card by its edges (without touching any components on the card) and pull it
straight out of the slot.
IMPORTANT
Do not rock the card side to side as you remove it. Doing so may
break the card or damage the slot.
Installing the port access cover
4Slide the port access cover into the port access opening at the back of the computer, to
cover the opening.
Use the port access cover that came with your computer (shown earlier in this
appendix).
Installing the audio ribbon cable
5Plug the audio ribbon cable into your CD-ROM drive and into the CD Audio
connector on the Macintosh logic board.
You need the audio ribbon cable that came with your computer (shown earlier
in this appendix). Plug either end of the cable into your CD-ROM drive,
thread it through the slot in the chassis, and plug the other end into the CD
audio connector on the Macintosh logic board (where you unplugged one of
the audio cables in step 1).
Replacing the computer’s cover
Replace the computer’s cover by following the instructions in Appendix B, in
the section “Replacing the Computer’s Cover.”
97
Removing the PC Compatibility Card From Your Power Macintosh 7300 Computer