Filter
Top Products
PowerBook G4 (15-inch FW 800_1.5/1.33GHz) Take Apart - 153
LCD Panel
Transfer or verify the sleep magnet installation
1. The round magnet on the back of the LCD panel triggers the computer’s sleep sensor.
2. If you are replacing the LCD panel, transfer the magnet to the new panel. Do not
transfer the half-donut shaped holder, if present. If the holder came installed on the
replacement panel, install the magnet in the center.
3. Important: Secure the magnet with a single piece of Kapton tape. To avoid pooling or
white spots, do not stretch the tape tight, or press down on the back of the LCD panel.
Verify or install the magnet approximately 6.5 cm from the top edge of the LCD panel,
and 1 cm from the left edge of the L-shaped panel strip.