Filter
Top Products
PowerBook G4 (15-inch FW 800_1.5/1.33GHz) Troubleshooting - 13
Hardware Symptom Charts
13. Repeat step 12 with the following flex cables one at a time, reconnecting each before
proceeding to the next cable:
• Sound/DC-in flex cable
• Hard drive flex cable
• Optical drive flex cable
• PC card cage flex cable
• Keyboard flex cable
• Trackpad flex cable
• Right USB flex cable
• Modem flex cable
If the computer starts up, inspect the flex cable connector and its connector on the
logic board for damage and replace the damaged parts.
14. Try known-good Sound/DC-in board.
15. Replace logic board.
Memory error message “The built-in memory test has detected an error”
appears on the screen
1. Run Apple Service Diagnostic Test. Note: If the failure is intermittent, run Apple
Service Diagnostic Test in loop mode (check looping options under Test Controls tab
and select only the RAM test under the Select Tests tab) for an extended time to test
the memory.
2. If the test can’t find the memory or finds bad memory, inspect the bad DIMM. Verify
proper memory is being used. The PowerBook G4 (15-inch FW 800) uses PC2700
(also called DDR333) DDR SDRAM SO-DIMMs with a maximum height of 1.25-inch
(30 mm). If improper memory is being used replace it. Otherwise, try reseating the
DIMM and retest. If still reported as bad, replace it.
3. Check the memory connector for damage (retention arms broken, connectors bent or
missing, connector lifted from logic board). If damage is detected replace the logic
board.