Filter
Top Products
154 - PowerBook G4 (15-inch FW 800_1.5/1.33GHz) Take Apart
LCD Panel
If reinstalling the bezel
1. Use Isopropyl alcohol wipes and a black stick to remove any residual adhesive along
the lower inside edge of the bezel. Rub the wipes vigorously over the adhesive and
scrape with the black stick. Verify that the adhesive is completely removed so that
there are no clumps of adhesive remaining that will create an uneven surface.
Warning: Sharp edges may be present.
2. Install the two replacement adhesive strips along the inside bottom edge. Peel an
adhesive strip from its backing, carefully position as shown below, and apply. Remove
the protective material over the adhesive strips before installing the LCD.
Important: Do not allow anything to come in contact with the adhesive while
positioning. The adhesive sticks to anything it touches, such as fingers, and will pull
off its backing and stretch out of shape.
If installing a replacement bezel
1. Remove the protective material over the adhesive before installing the LCD. If
adhesive is not present, install as instructed above.
Reassemble and test the computer
Important: After the computer is reassembled, verify that the magnet is in the correct
location by closing the display while the computer is running. The computer should
go to sleep.
Adhesive strips