Filter
Top Products
6 -
PowerBook G4 (15-inch FW 800_1.5/1.33GHz) Take Apart
Foot
Procedure
Warning:
The glue used in this procedure can bond instantly to skin. Do not touch the
glue. In the event of contact, review the safety instructions at the end of this document. For
additional information, refer to the glue manufacturer:
Elmer's Products, Inc.
Columbus, OH. 43215-3799
www.krazyglue.com
1. Place the computer upside down on a clean, lint-free cloth or other nonabrasive
surface.
2. Select a foot from the kit. Verify that the case plug and case foot match (refer to the
images shown in the table). Do not use a foot that does not match.
3. Make sure the plug area on the bottom case is clean. If any portion of the soft rubber
foot remains, remove it so that only the hard plastic plug is visible.
Important:
When positioning the foot, make sure the indents and bumps of the
rubber foot match up and fit into the corresponding indents and bumps in the plug.
This ensures a balanced and level fitting. (Note: The picture below is of a different
foot than on the computer, and is for illustration only.)