Filter
Top Products
156 - PowerBook G4 (15-inch FW 800_1.5/1.33GHz) Take Apart
Display Bezel
Procedure
Important: Do not remove or loosen screws on the clutches. The clutches are not self-
aligning and even a 0.3 mm shift will be noticeable.
Important: If uneven pressure is applied to the bezel, it can be bent out of alignment.
Avoid twisting the bezel.
With all preliminary steps performed, the bezel is the remaining part.
Replacement Procedure
If installing a replacement bezel
1. Remove the clutch block and clutch assembly on the replacement bezel, if present.
They may not be aligned for the computer and will not be used.
2. Transfer the clutch blocks with clutches attached, to the replacement bezel, by
removing the three T8 screws on each one.
Important: Do not remove or loosen screws on the clutches. The clutches are not
self-aligning and even a 0.3 mm shift will be noticeable.
3. Remove the adhesive backing along the bottom inside bezel edge. If adhesive is not
present, follow the procedure in the LCD chapter to install.
If reinstalling the bezel
1. Follow the procedure in the LCD chapter to remove the residual adhesive, and to
install new adhesive.
To install the bezel
1. Place the bezel face down on a table with the clutches positioned over the edge.