Filter
Top Products
57
Fault Cause Remedy
Projector does not work with IR Projector not switched on? Switch on projector.
Remote control
Low remote control battery? Replace battery.
IR-window on front of projector Make IR-window accessible for transmitter pulse.
is screened off by obstacles in room?
Battery in remote control is placed in wrong direction (reversed polarity) Insert battery correctly and try again.
IR-remote control defective Call ARRI Service station.
Image runs out of focus Jet underneath film gate clogged. Remove foreign matter.
when switching over from still
to motion picture (and vice-versa) Blower break-down. Call ARRI Service station.
Guide vane misadjusted. Call ARRI Service station.
Positive film has scratches Emulsion buildup in film gate. Clean emulsion deposits from film gate
on emulsion side in picture area using ARRI plastic scewer.
Film gate damaged by stapled film. Call ARRI Service station.
Negative film has scratches Emulsion buildup on pressure pad of film stage Remove emulsion deposit from pressure pad,
on emulsion side in picture area using ARRI film track cleaning scewer.
Trouble-Shooting