80
Service Instructions
Service work only by instructed personnel!
Caution: Danger of injury!
Before replacing of lamp allow approx.
2 minutes for cooling.
Note: Cooling blower is only active when projector is
switched on.
1) Disconnect LOCPRO 35 completely from mains.
2) Remove lamp hood.
Caution: Danger of injury
After operation the metal plate hood covering
of the lamp housing is hot. To avoid burns
allow for cooling.
3) Open fixing screw of safety locking bar on plate hood
➪ photo with hex. Wrench 3 mm until safety locking
bar can be twisted by 90°. Swing away the plate
hood which covers the lamp housing.
Service Instructions
snap locks lamp cover