Filter
Top Products
Introduction
Page 1-10
Factory
Defaults
The IntraSwitch 5212 is shipped with the following
configuration default settings:
Table 1-2 Factory Default Configurations
▲ Important! When the IntraSwitch 5212 is
reset (powered off and then on), all settings are
returned to the factory defaults listed above
except for the IP Address, Subnet Mask, and
Default Gateway; these items revert to the first
addresses assigned to them.
Configuration Default Setting
IP address 0.0.0.0
Important! The first IP address that is
assigned to the IntraSwitch becomes the new
factory default setting.
Subnet Mask 0.0.0.0
Important! The first subnet mask that is
assigned to the IntraSwitch becomes the new
factory default setting.
Default Gateway 0.0.0.0
Important! The first default gateway
address that is assigned to the IntraSwitch
becomes the new factory default setting.
Switching Mode Store-and-forward
10Base-T Ports Half duplex
10/100TX Port and
Asanté MII
Expansion Port
Auto-negotiation
Spanning Tree Enabled on ALL ports
book Page 10 Monday, March 2, 1998 4:27 PM