Filter
Top Products
Console Management
Page 5-32
3
Select the port number you want to enable
or disable Spanning Tree on by typing l on
the Port Parameter Menu and entering the
port number at the prompt.
∆ Note: The 10/100TX port is port num-
ber 13, the installed Asanté MII module is
port number 14.
4
Press Return.
5
Type e to enable Spanning Tree on the port;
type d to disable Spanning Tree on the port.
6
Type q to exit this menu and return to the
Spanning Tree Parameter Menu.
7
Type a to apply the changes.
▲ Important! The change will not take
effect until Apply is selected from the
Spanning Tree Parameter Menu.
book Page 32 Monday, March 2, 1998 4:27 PM