Audiovox 600E Printer User Manual


 
Getting Started 2-3
NovaJet PRO 600e User's Guide
GETTING STARTED
! IMPORTANT! Depending on the model, the printer can use media up to 60" wide. The
rolls can be heavy, so you may want to have someone help you to load them. Before
starting, be sure that you have a take-up roll core available which is the same width as the
media you are loading.
! If your roll media has wrinkled or damaged edges, cut off the damaged part of the roll
prior to loading to prevent the media from jamming in the printer.
! IMPORTANT! Be sure to use only ENCAD QIS media. Tests have shown that the use of
non-ENCAD media can generate sufficient electrostatic discharge to cause shorting and
damage to the LED display.
Using the power media feed and take-up system
The power media feed and take-up system facilitates long, unattended printing runs by
automatically unwinding and rewinding media as prints are generated. It includes a feed roll, a
take-up roll, and sensors which prevents media from coming into contact with the floor.
When the unit is first turned on, the feeder may turn for a few seconds. If the take-up turns, the
sensor is blocked. Clear anything blocking the take-up sensor before proceeding.
To load roll media
1 Slide the rolled media onto the media (upper) roller, orienting it as shown below.
Slide the paper guide into the roll core, and tighten the guide to secure the roll by
turning the blue knob clockwise. Standing behind the printer, insert the media's
leading edge into the back of the printer, aligning the paper edge with the alignment
mark on the platen. The printer will sense the presence of the media and after the
default 6-second delay, will automatically feed it.