Filter
Top Products
Getting Started 2-5
NovaJet PRO 600e User's Guide
GETTING STARTED
Note: If you are running narrow media, and depending on ambient temperature and humidity,
you may want to set a dry time and/or turn on the dryer as described in Chapter 3 if you are
running a long plot. Because of the print speed and the narrow media, the ink may otherwise
not have sufficient time to dry before the media is rolled onto the take-up core.
➪➪
➪➪
➪ To unload the take-up roll
1 Press the Cut button to cut the media.
2 Release the adjustable roll guide.
3 Slide the media and core out of the printer.
➪➪
➪➪
➪ To load sheet media
1 Press Setup/Paper Options/Supply Type/Sheet. Press OK.
2 Load the sheet from the back of the printer, aligning it with the alignment mark on
the platen.
3 Make sure that the media is flat and under the rollers. The printer will automatically
sense the media's presence and load it until it reaches the start position on the
platen.
Moving the carriage
When not in use, the cartridges rest in the service station at the right side of the printer. This
device seals the inkjets to prevent them from drying out. If power is turned on, always use
the Utility/Access Cartridges button to move the carriage away from the service
station so that you can install, change, adjust or clean the ink cartridges or the service
station.
Installing the cutter
You need to install the cutter if you want the printer to automatically cut the media after
printing. Replacement cutters are available from your ENCAD supplies dealer.
! Be careful when handling the cutter to avoid injury.
! Do not use an external knife to cut media as this can damage the platen and
prevent the media sensors from operating correctly.
➪➪
➪➪
➪ To install the cutter
1 Press the Access Cartridges button to move the carriage to the left, out of the
service station.