Filter
Top Products
NovaJet PRO 600e User's Guide
4-4 Printer maintenance and storage
➪➪
➪➪
➪ To reuse the cartridge
1 Remove the cartridge from its garage by pulling back on the garage locking
tab and gently taking out the cartridge.
2 On the printer display panel, press Utility Menu then Access Cartridge.
3 Snap the cartridge tube connector quick connect fitting into the fitting on the
carriage.
4 Insert the cartridge into its carriage stall, making sure that there are no kinks
in the ink delivery line. (Refer to Chapter 2.)
5 On the printer display panel, press Utility Menu then Access Cartridge to
return the carriage to the service station.
6 Run a prime to ensure that all jets are clear and operating correctly.
7 If the cartridge leaked during storage or the cartridge lost negative pressure,
you will need to reprime the cartridge with the NovaPrime to reestablish
negative pressure. (Refer to Chapter 2.)
Note: Cartridges stored for extended periods of time will probably need to be cleaned,
blotted and primed before use because the garages are designed only for short term
cartridge storage.
Replacing the reservoirs
1 Remove all the cartridges before replacing the ink reservoirs.
2 Open the left front cover to access the reservoirs. Leave the caps on the
reservoirs. Disconnect the quick connect fitting for each reservoir, noting the
color of the fitting to which it was connected.
3 Slide each reservoir forward to remove it from the printer.
Store the reservoirs away from direct sunlight in an environment similar to that
of the printer.
4 Replace the reservoirs with new reservoirs.
5 Fill the reservoirs with ink and attach to the quick connect fittings primed for
that type of ink.