Filter
Top Products
NovaJet PRO 600e User's Guide
2-6 Getting Started
The cutter fits in the slot on the left side of the car-
riage. Install the cutter by inserting it into the carriage.
2 Push the cutter into the slot until it clicks into place.
3 Press the Access Cartridges button to move the
carriage back into the service station. This ensures
that the cutter blade is in the home position.
➪➪
➪➪
➪ To remove the cutter
1 Press the Utility/Access Cartridges button to move the carriage to the center of the
platen.
2 Press the knife latch down.
3 Pull the cutter out of the carriage.
When the cutter becomes worn, it can cause the carriage to jam or can cause a ragged media cut.
In extreme cases, you might see an error message stating "Carriage Axis Failure".
You can order replacement cutters from ENCAD by calling
800-45-ENCAD, (619-677-5071) or fax ENCAD at 619-549-7894. Users outside the U.S. can
call their local ENCAD dealer or sales center.
Filling the ink reservoirs
! Use of inks other than ENCAD NovaJet PRO 600e series ink may not give the
desired results on finished prints.
The printer can support long, uninterrupted printing runs because of its extended ink capacity.
The ink reservoirs are located at the printer's left side.
Note: When running at carriage speeds faster than the default, it is recommended that
ink levels in the reservoirs be no more than 300ml (maximum).