Audiovox 600E Printer User Manual


 
NovaJet PRO 600e User's Guide
3-12 Printer Options
Defaults for the heater setting are determined by the ink type in use. The printer determines this
by reading the chip on the back of each cartridge. When you adjust the ink settings, you are
increasing or decreasing the heat from the default temperature. Pressing the + (plus) button
increases the temperature, pressing - (minus) decreases it. When you have reached the limits of
the temperature range, the panel will display either MAX or OFF. These settings are saved in the
printer. If you change to a different type of ink, you may need to change the heater settings to
accommodate the new ink type.
If you are working in a cold or dry environment, try turning the heat up for a larger dot size. If the
heat is turned up too far, the ink may run or sputter. If you are working in a humid or hot environ-
ment, turn the heat down for a smaller dot size.
To set the ink preheat time
1 Press Setup/Ink Option/Ink Preheat.
2 Choose a preheat value.
3 Press OK.
Dry time
Unattended prints might require drying time to prevent the ink from smearing when the image
touches the takeup roll or previously printed images. In addition, you may want to change drying
time depending on the media you are using, the ambient temperature and the humidity. Dry Time
values range from 10 seconds to 60 minutes. When the Dry Time has expired, the printer rolls or
cuts the image and begins printing the next image in the buffer.
To set the dry time
1 Press Setup/Ink Option/Dry Time.
2 Choose a time from 10 seconds to 60 minutes.
3 Press OK.
Dryer On/Off
The dryer installed at the base of the printer stand helps to dry ink.
To enable the dryer
1 Press Setup/Ink Option/Dryer.
2 Choose On.
3 Press OK.