Filter
Top Products
72 AMX Switch Series Installer/User Guide
To set the IP mode:
1. In the Main Menu, select option 1, Network Configuration, and press
Enter. The Network
Configuration menu opens.
2. Select option 1, IP Configurat
ion, and press Enter. The IP Configuration menu opens.
3. Select the desired IP configuration option (IPv4 St
atic, IPv6 Static or IPv6 Auto) and press
Enter. An option-dependant Network Configuration menu opens.
NOTE: When IPv6 Auto is selected, the MAC address of the unit is used to build an IPv6 address. This option
does not allow the IP address, prefix length or default gateway to be edited.
4. Depending on the IP configuration option chosen, use the appropriate format to enter an IP
address and press
Enter.
5. Select option 0, Exit, to exit the Network Configuration menu.
System Management
The AMX switch uses IP to communicate with the AMWo
rks software and synchronize all AMX
switch databases. You can provide a unique ID for each AMX switching system configuration so
that multiple configurations can be connected to and managed on the same subnet.
All AMX switches that are part of the same AMX configuration should have the same
configur
ation
ID.
NOTE: Configuration ID can only be used in IPv4 mode.
Set the IDs of all AMX switching system configurations that will be connected to the same subnet
as shown in the following table. Continue this numbering system for all other AMX switching
system configurations connected to the same subnet.
Set/Change Password
You can set the AMX switch to a secure mode so th
at the Terminal Applications menu cannot be
accessed without first entering a password.
To activate security:
1. Select the Set/Chan
ge Password menu option. You will be prompted to decide if you wish to
continue. Enter a
Y.
Table 4.1: AMX Switching System Configuration ID
System Configuration ID
system 1 000001
system 2 000002
system 3 000003
AMX.book Page 72 Thursday, June 12, 2008 4:14 PM