Filter
Top Products
3-4
Installation Guidelines
5976072 BARCO ELM R12 17102000
AIR IN
IR OUT
Safety area for air in & out
Image 7
Image 6
Image 6a
Warning on Rotating the Projector
When the lamp casing is installed, it is not allowed to rotate the projector clockwise when facing the lenses. An internal tilt switch
will provide to start up the projector.
Correct way of rotating the projector, see image 6a.
Safety Area around the Projector
Make sure the projector is located so that the air inlets and outlets for the cooling system are not obstructed.
Leave a safety areo of about 1 meter on the left and the right side of the projector.
Installation of the Lamp Casing
Lamp Casing Warnings
Never transport the projector with the lamp casing installed.
The lamp casing should always been transported in a vertical way to avoid damaging the lamp.
Never attempt to disassemble the lamp from its housing or to dispose of it other than by returning it to BARCO. Due to its high internal
pressure, the lamp may explode in either hot or cold state.