Filter
Top Products
5-3
Getting Started
5976072 BARCOELM R12 17012000
-
+
-
+
-
+
-
+
-
+
0
9
7
8
65
43
21
32a
-
+
?
COLORPHA S E
SHA R PN T IN T BRI GH TN
STANDBY
ENT ER
TEXT
EX IT
PAUSE
$
Operating the Projector
Switching on
Use the power switch to switch on.
When '0' is visible, the projector is switched off.
When '1' is visible, the projector is switched on.
When switching on with the power switch, the projector starts in the stand by mode. The projector mode indication lamp is red.
To start image projection :
a. press the 'Stand by' button A on the local keypad or on the remote control. The projector mode indication lamp will be green.
b. press a digit button to select an input source. The projector mode indication lamp will be green.
Lamp Run Time Indication
When starting up and the total run time of the lamp is 470 hours or more, the lamp remaining run time will be displayed for 1 minute.
This warning message will be repeated every 30 minutes. Press EXIT to remove the message before the minute is over.
When the total run time of the lamp is 500 hours or more, the following warning message, with the exact run time is displayed on
the screen.
Lamp run time is 500 hours. Operating the lamp longer than 500 hours may damage the projector. Please replace the lamp.
When OK (ENTER) is pressed to go on, the warning will be repeated every 30 min.
The total lifetime of the lamp for a safe operation is 500 hours max. Do not use it longer. Always replace with a same type of lamp.
Call a BARCO authorized service technician for lamp replacement.
Lamp Run Time Warning
Using a lamp for more than 500 hours is dangerous as the lamp could explode.
REMAINING LAMP RUN TIME
30 h
<ENTER> to continue
WARNING
Lamp run time is 500 hours
Operating the lamp longer
than 500 hours may damage
the projector.
Please replace the lamp