Filter
Top Products
5-2
Getting Started
5976072 BARCOELM R12 17012000
Terminology
1 Barco key : = selection key, to get direct access to the lens adjustment menus.
2 ADJ. : ADJUST key, to enter or exit the adjustment mode.
3Address key (recessed key), to enter the address of the projector (between 0 and 9). Press the recessed address key with
a pencil, followed by pressing one digit button between 0 and 9.
4 STBY : stand-by button, to start projector when the power switch is switched on and to switch off the projector without
switching off the power switch.
5 PAUSE : to stop projection for a short time, press 'PAUSE'. The image disappears but full power is retained for immediate restarting.
6 Help : on line help information (not yet available)
7 Digit buttons : direct input selection.
8 Picture controls : use these buttons to obtain the desired picture analog level.
9 PHASE : used to remove the instability of the image.
10 TEXT : when adjusting one of the image, e.g. controls during a meeting, the displayed bar scale can be removed by pressing
'TEXT' key first. To re-display the bar scale on the screen, press 'TEXT' key again.
When TEXT is 'off', no adjustment menu's will be displayed on the screen when entering the adjustment mode.
11 FREEZ : press to freeze the projected image.
12 ENTER : to start up the adjustment mode or to confirm an adjustment or selection in the adjustment mode.
13 EXIT : to leave the adjustment mode or to scroll upwards when in the adjustment mode.
14 Cursor Keys (on RCU) or '+' and '-' keys (cursor keys) on the local keypad : to make menu selections when in the adjustment
mode or to zoom/focus when the direct access is active.
Comparision between the cursor keys and the use of the '+' and '-' keys on the local keypad :
RCU = local keypad
cursor key up = '+' key up
cursor key down = '-' key down
cursor key right = '+' key right
cursor key left = '-' key left
Use the '+' and '-' keys (cursor keys) : to increase or decrease the analog level of the image controls when they are first selected.
15 RC operating indication : lights up when a button on the remote control is pressed. (This is a visual indicator to check the
operation of the remote control)