Filter
Top Products
5-4
Getting Started
5976072 BARCOELM R12 17012000
Select with é or ê
then <ENTER>
<EXIT> to return.
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
SERVICE
Select with é or ê
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
LAMP
MORE..
Select with é or ê
then <ENTER>
<EXIT> to return.
CHANGE LANGUAGE
English
menu 1 menu 2 menu 3
Lamp Light Output Indication
When starting up and the center lumens measurement is lower than 50 % of its initial value, the lamp light output warning will be displayed
for 1 minute. Press ENTER to continue. The message will not be repeated during operation.
<ENTER> to confirm
WARNING
Lamp run time is 400 hours.
The light output of the lamp is less
than 50% of its initial value.
It is advisable to replace the lamp
before damage occurs.
During operation and a start up without any message, the light output message will appear on the screen when the light output is
reduced with 33% from its initial value.
This message will be repeated every hour.
Switching to Stand-by.
When the projector is running and you want to go to stand-by, press the stand-by key.
Switching Off
To switch off:
- First press STANDBY key and let the projector cool down until the fans stopblowing, or at least 15 min.
- Switch off the projector with the power switch.
Quick Set Up Adjustments
Quick Language Change
Only if different on screen languages are available, follow the next procedure to change the on screen language.
1 Press ENTER to start up the adjustment mode.
2 Press the cursor key é or ê to highlight 'Service' (menu 1). When password protected, your password will be asked.
(more explanation about access by password can be found in Chapter 'Start up the Adjustment mode'.
3 Press ENTER to display the Service mode menu.
3 Push the cursor key é or ê to highlight 'Change Language' (menu 2). If not visible in the menu, highlight first 'More' and press
ENTER to display a second service menu. Select then 'Change Language'.
4 Press ENTER to display the language selection menu.
5 Push the cursor key é or ê to highlight the desired language (menu 3).
For the moment, only English is available.