Barco R9001490 Projector User Manual


 
Service Mode
9-2 5976072 BARCOELM R12 05052000
ADD-INS
LIGHT SENSOR : [INACTIVE]
Select with é or ê
<ENTER> to toggle/select
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
LAMP
MORE...
Select with é or ê
then <ENTER>
<EXIT> to return.
SERVICE
BARCO LOGO
PRESET INPUT BALANCE
ADD INS
I2C DIAGNOSIS
MORE...
Select with é or ê
then <ENTER>
<EXIT> to return.
BARCO LOGO
STATUS : [ON]
BACKGROUND : [ON]
SHIFT
HOT KEY : [TEXT]
Select with é or ê
<ENTER> to toggle/select
<EXIT> to return.
I2C DIAGNOSIS
DCA
DECODER 12H # ##
MOTOR DRIVER 1AH ## #
LIGHT SENSOR 1CH ###
LAMP DRIVER 20H ###
LAMP DRIVER 22H ###
POWER SUPPLY 30H ###
INPUT SELECTOR 46H ###
PMP INPUT SELECTOR 4AH ###
INPUT SELECTOR 7EH ###
LAMP MODULE A0H # # #
PRESET INPUT BALANCE
WHITE BALANCE
BLACK BALANCE
DEFAULT
Select with <ENTER>
<EXIT> to return
Adjust
red with é or ê
blue with è or ç
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
LAMP
MORE...
Select with é or ê
then <ENTER>
<EXIT> to return.
Identification
How to display the Identification screen ?
1 Push the cursor key é or ê to highlight 'Identification' (menu 1).
2 Press ENTER to display the Identification screen (menu 2.
Scroll with é or ê
<EXIT> to return.
menu 1 menu 2
The information
The following information is available on the identification screen:
- type of projector
- projector address
- software version
- installation configuration
- baud rate
- text ON
- projector serial number
- projector run time
Detailed description
- type of projector : BARCOELM R12
- software version
- Proj. Address : to change the address of the projector, see Change Projector Address in this chapter.
- Installation : possible installations :
* Front/Ceiling
* Front/Table
* Rear/Ceiling
* Rear/Table
To change the installation configuration, follow the instructions in chapter 'Installation Guidelines'.
- Baud rate : transfer speed for communication with an IBM PC (or compatible) or MAC. The baud rate of the projector must be the
same as the baud rate of the connected computer. When there is a difference, consult 'Change Baudrate PC' in this chapter.
Select with é or ê
then <ENTER>
<EXIT> to return.
BARCO
ELM R12
Proj. address : 001
Soft. version : 3.0
Config : front/
ceiling
Baudrate PC : 9600
text : ON
Serial no.: 1010200
Run time : 100 h