Filter
Top Products
Service Mode
9-7
5976072 BARCOELM R12 05052000
Select with é or ê
then <ENTER>
<EXIT> to return.
Select with é or ê
<ENTER> to toggle
<EXIT> to return.
LAMP
Constant light output [YES]
Serial number : R101111
Type : B400049
Run time : 10 hours
Remaining run time : 490 hours
Number of strikes : 10
menu 2
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
LAMP
MORE...
Lamp
Lamp information light output switching.
All information about the lamp is stored inside the lamp house and can be displayed via the projector software on the projection screen.
No information can be changed.
The Constant light output function can be changed between yes and no.
How to display the lamp menu.
1 Push the cursor key é or ê to highlight 'Lamp' (menu 1).
2 Press ENTER to select.
The lamp menu will be displayed (menu 2)
Which information is available ?
Serial number : unique serial number of the lamp.
Type : lamp type.
Run time : total time the lamp is used in this or other projectors.
Remaining run time : time left before the lamp must be replaced
Using the lamp longer than the maximum run time (500 hours) may damage the projector.
Number of strikes : Total times the lamp is started up.
menu 1
How to switch the constant light output ?
1 Push the cursor key é or ê to highlight 'Constant Light Output' (menu 1).
2 Press ENTER to toggle between [YES] and [NO].
[YES] : constant light output, power will be adapted.
[NO] : fixed power, no power adaptation.
When gray out : light sensor is not available or not activated.
BARCO logo
What can be done ?
The BARCO logo can be added to the image, in overlay or on a background, on any place on the screen.
How to add or the change the settings ?
To add the BARCO logo or to change a setting in the BARCO logo menu:
1 Push the cursor key é or ê to highlight 'BARCO logo' (menu 1).
2 Press ENTER to select.
The BARCO logo menu will be displayed on the screen (menu 2. Within this menu, three toggle settings and a shift control are
available.
SERVICE
BARCO LOGO
PRESET INPUT BALANCE
ADD-INS
I2C DIAGNOSIS
MORE...
BARCO LOGO
STATUS : [ON]
BACKGROUND : [ON]
SHIFT
HOT KEY : [TEXT]
Select with é or ê
then <ENTER>
<EXIT> to return.
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
menu 2