Belkin 5232K Switch User Manual


 
23
OmniViewIP 5216K/5232K
SECTIONSTable of Contents 1 2 4 5
6
3
WEB INTERFACE
Security > Settings
Configure the security features, such as Account Blocking, Password
Policy,andIdleTimeout,asexplainedbelow.
From the Security section, click “Settings”. The “Security > Settings”
page appears (see Figure 20).
Figure 20 Security Settings
Password Policy
For local and remote users, you have the option of a standard or high
security level of password. The table below shows the parameters of the
two options.
Standard
security policy
High security policy
6 characters or
more
8 characters or more, must include at least 1
digit and 1 uppercase letter, and 1 “special”
characterasfollows:!@#$%^*()_-+=[]’:;?/
Must not include
the user name
Must not include the user name
Checktheboxtoenablethehighsecuritypasswordpolicy.Ifleft
unchecked, the standard security policy applies.
OSD password enabled – For the local user, access to the OSD can
be password enabled or disabled (default), with the option of a standard
orhighsecuritylevelofpasswordasexplainedabove.Selectthecheck
boxtoenablepassword.
Note! The user access permissions are the same whether access is
done locally or remotely.
Idle Timeout – Select the timeout inactivity period after which the user
is disconnected from the system. Choose “No Timeout” to disable
timeout.
Click to save any security changes.
Security Settings fields:
Account Blocking – Decide on the number of attempts to log in with a
wrong user name or password, after which there is a time lock or a
total block.