Filter
Top Products
1312
1312
Knowing your N1 Vision
section
1
9
2
3
4
5
6
7
8
10
E. Connections to Wired Computers – Gray Ports
Connect your wired (non-wireless) computers to these ports.
These ports are RJ45, 10/100/1000 auto-negotiation, auto-
uplinking ports for standard UTP category 5 or 6 Ethernet cable.
The ports are labeled 1 through 4. Use the gray cable provided to
connect your computer to any one of these ports.
F. Connection to Modem – Yellow Port
This port is for connection to your cable or DSL modem. Use the
cable that was provided with your modem to connect the modem
to this port. Use of a cable other than the one supplied with the
cable modem may not work properly.
G. Reset Button
The “Reset” button is used in rare cases when the N1 Vision
may function improperly. Resetting the N1 Vision will restore the
N1 Vision’s normal operation while maintaining the programmed
settings. You can also restore the factory default settings by
using the “Reset” button. Use the restore option in instances
where you may have forgotten your custom password.
i. Resetting the N1 Vision
Push and release the “Reset” button. The lights on the N1
Vision will momentarily flash. The “Power/Ready” light will
begin to blink. When the “Power/Ready” light becomes solid
again, the reset is complete.
ii. Restoring the Factory Defaults
Press and hold the “Reset” button for at least 10 seconds,
then release it. The lights on the N1 Vision will momentarily
flash. The “Power/Ready” light will begin to blink. When
the “Power/Ready” light becomes solid again, the restore
is complete.
H. Power Jack – Black
Connect the included 12V/1.25A DC power supply to this jack.