Filter
Top Products
5352
Using the Web-Based Advanced User Interface
5352
Using the Broadcast SSID Feature
Note: This advanced feature should be employed by advanced users
only. For security, you can choose not to broadcast your network’s SSID.
Doing so will keep your network name hidden from computers that are
scanning for the presence of wireless networks. To turn off the broadcast
of the SSID, remove the check mark from the box next to “Broadcast
SSID”, and then click “Apply Changes”. The change is immediate. Each
computer now needs to be set to connect to your specific SSID; an SSID
of “ANY” will no longer be accepted. Refer to the documentation of your
wireless network adapter for information on making this change.
Protected Mode Switch
Protected mode ensures proper operation of N1, draft 802.11n-compliant
devices on your wireless network when 802.11g or 802.11b devices
are present or when there is heavy 802.11g or 802.11b traffic in the
operating environment. Use protected mode if your network consists of
a mix of Belkin N1 Wireless Cards and 802.11g or 802.11b cards on your
network. If you are in an environment that includes little to no 802.11g
or 802.11b wireless network traffic, you will achieve the best N1 wireless
performance with protected mode OFF. Conversely, in an environment
with HEAVY 802.11g or 802.11b traffic or interference, you will achieve
the best N1 wireless performance with protected mode ON. This will
ensure N1 wireless performance is not affected.
Changing the Wireless Security Settings
Your N1 Vision is equipped with the latest security standard called
Wi-Fi Protected Access
™
2 (WPA2
™
) and the legacy security standard
called Wired Equivalent Privacy (WEP). Your N1 Vision also supports
the Wi-Fi Protected Setup (WPS) specification, which simplifies the
setup of a wireless network. WPS uses familiar methodologies, such
as typing in a Personal Identification Number (PIN) or pushing a
button, to enable users to automatically configure network names
and strong WPA/WPA2 data encryption and authentication. By
default, your N1 Vision does not ship with security enabled. You may
automatically configure the security settings using WPS. To change
the security settings manually, you will need to determine which
standard you want to use. To access the security settings, click
“Security” on the “Wireless” tab.