Filter
Top Products
Operation 27
If you forget the password
If you forget the passwordIf you forget the password
If you forget the password
If the password function is activated, you will be asked
to enter the six-digit password every time you turn on
the projector. If you enter the wrong password, the
password error message as pictured to the right displays
lasting for 3 seconds, and the INPUT PASSWORD
INPUT PASSWORDINPUT PASSWORD
INPUT PASSWORD
message follows. You can retry by entering another six-
digit password, or if you did not record the password in
this manual, and you absolutely do not remember it, you can use the password recall
procedure. See "Entering the password recall procedure" on page 27 for details.
If you enter an incorrect password 5 times in succession, the projector will automatically
shut down in a short time.
Entering the password recall procedure
Entering the password recall procedureEntering the password recall procedure
Entering the password recall procedure
1. Press and hold AUTO
AUTOAUTO
AUTO on the projector or
remote control for 3 seconds. The projector
will display a coded number on the screen.
2. Write down the number and turn off your
projector.
3. Seek help from the local BenQ service
center to decode the number. You may be
required to provide proof of purchase
documentation to verify that you are an
authorized user of the projector.
Changing the password
Changing the passwordChanging the password
Changing the password
1. Open the OSD menu and go to the SYSTEM SETUP: Advanced
SYSTEM SETUP: AdvancedSYSTEM SETUP: Advanced
SYSTEM SETUP: Advanced> Security Settings
Security SettingsSecurity Settings
Security Settings >
Change Password
Change PasswordChange Password
Change Password menu.
2. Press Mode/Enter
Mode/EnterMode/Enter
Mode/Enter. The message “INPUT CURRENT PASSWORD”
“INPUT CURRENT PASSWORD”“INPUT CURRENT PASSWORD”
“INPUT CURRENT PASSWORD” displays.
3. Enter the old password.
i. If the password is correct, another message “INPUT NEW PASSWORD”
“INPUT NEW PASSWORD”“INPUT NEW PASSWORD”
“INPUT NEW PASSWORD” displays.
ii. If the password is incorrect, the password error message displays lasting for three
seconds, and the message “INPUT CURRENT PASSWORD”
“INPUT CURRENT PASSWORD”“INPUT CURRENT PASSWORD”
“INPUT CURRENT PASSWORD” displays for your
retry. You can press Menu/Exit
Menu/ExitMenu/Exit
Menu/Exit to cancel the change or try another password.
4. Enter a new password.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected
password down here in this manual in advance or right after the password is entered so that it
is available to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
5. Confirm the new password by re-entering the new password.
6. You have successfully assigned a new password to the projector. Remember to enter the
new password next time the projector is started.
7. To leave the OSD menu, press Menu/Exit
Menu/ExitMenu/Exit
Menu/Exit.
..
.
Password Error
Please try again.
Please write down the recall code,
and contact BenQ
Customer Center.
Recall Code:
0 2 1 2
RECALL PASSWORD
Exit
MENU