Filter
Top Products
Troubleshooting60
Troubleshooting
TroubleshootingTroubleshooting
Troubleshooting
The projector does not turn on.
The projector does not turn on.The projector does not turn on.
The projector does not turn on.
No picture
No pictureNo picture
No picture
Blurred image
Blurred imageBlurred image
Blurred image
Remote control does not work
Remote control does not workRemote control does not work
Remote control does not work
The password is incorrect
The password is incorrectThe password is incorrect
The password is incorrect
Cause Remedy
There is no power from the power
cord.
Plug the power cord into the AC power jack on
the projector, and plug the power cord into the
power outlet. If the power outlet has a switch,
make sure that it is switched on.
Attempting to turn the projector on
again during the cooling process.
Wait until the cooling down process has
completed.
Cause Remedy
The video source is not turned on or
connected correctly.
Turn the video source on and check that the
signal cable is connected correctly.
The projector is not correctly
connected to the input signal device.
Check the connection.
The input signal has not been
correctly selected.
Select the correct input signal with the
SOURCE key on the projector or remote
control.
The lens cover is still closed. Open the lens cover.
Cause Remedy
The projection lens is not correctly
focused.
Adjust the focus of the lens using the focus
ring.
The projector and the screen are not
aligned properly.
Adjust the projection angle and direction as
well as the height of the projector if necessary.
The lens cover is still closed. Open the lens cover.
Cause Remedy
The batteries are out of power. Replace the batteries with new ones.
There is an obstacle between the
remote control and the projector.
Remove the obstacle.
You are too far away from the
projector.
Stand within 8 meters (26 feet) of the
projector.
Cause Remedy
You do not remember the password.
Please see "Entering the password recall
procedure" on page 27 for details.