Filter
Top Products
Operation28
Disabling the password function
Disabling the password functionDisabling the password function
Disabling the password function
To disable password protection, go back to the SYSTEM SETUP: Advanced
SYSTEM SETUP: AdvancedSYSTEM SETUP: Advanced
SYSTEM SETUP: Advanced > Security
Security Security
Security
Settings
SettingsSettings
Settings >
> >
> Power On Lock
Power On LockPower On Lock
Power On Lock menu after opening the OSD menu system. Press Mode/Enter
Mode/EnterMode/Enter
Mode/Enter.
. .
.
The message “INPUT PASSWORD”
“INPUT PASSWORD”“INPUT PASSWORD”
“INPUT PASSWORD” displays. Enter the current password.
i. If the password is correct, the OSD menu returns to the Security Settings
Security SettingsSecurity Settings
Security Settings page.
Press to highlight Power On Lock
Power On LockPower On Lock
Power On Lock and press / to select Off
OffOff
Off. You will not
have to enter the password next time when turning on the projector.
If the password is incorrect, the password error message displays lasting for three
seconds, and the message “INPUT PASSWORD”
“INPUT PASSWORD”“INPUT PASSWORD”
“INPUT PASSWORD” displays for your retry. You can
press Menu/Exit
Menu/ExitMenu/Exit
Menu/Exit to cancel the change or try another password.
Though the password function is disabled, you need to keep the old password in hand should
you ever need to re-activate the password function by entering the old password.
Correcting keystone
Correcting keystoneCorrecting keystone
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the
top or bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, if you are using the MP776 ST
and would like the projector to automatically correct image keystoning, be sure the Auto
Auto Auto
Auto
Keystone
KeystoneKeystone
Keystone function in the DISPLAY
DISPLAYDISPLAY
DISPLAY menu is On
OnOn
On.
Or you will need to manually correct it following ONE of these steps.
• Using the remote control
Press / on the projector or remote control
to display the Keystone correction page. Press to
correct keystoning at the top of the image. Press
to correct keystoning at the bottom of the image.
• Using the OSD menu
1. Press Menu/Exit
Menu/ExitMenu/Exit
Menu/Exit and then press / until the
DISPLAY
DISPLAYDISPLAY
DISPLAY menu is highlighted.
2. Press to highlight Keystone
KeystoneKeystone
Keystone and press Mode/
Mode/Mode/
Mode/
Enter
EnterEnter
Enter. The Keystone
KeystoneKeystone
Keystone correction page displays.
3. Press to correct keystoning at the top of
the image. Press to correct keystoning at
the bottom of the image.
Press /.
Press /.