Filter
Top Products
ETEP Introduction
ETEP Installation Guide 11
Status Indicators
The ET0010A status indictors are shown in Figure 3. The status indications are described in Table 1.
Figure 3 ET0010A Status Indicators
The following table describes how to interpret the ET0010A status indicators.
Rear Panel
The ET0010A rear panel and external power supply are shown in Figure 4.
Elements of Figure 3:
1) Power LED
2) Alarm LED
3) Status indicators
4) Link indicators
Table 1 ET0010A Status Indicators
Indicator Light State Indication
Power (green) Off Unit is powered off.
On Unit is powered on.
10/100 link status
(green)
a
a. The link status LEDs are on the remote and local data ports, Ethernet management port, and Aux1 port.
Off Loss of signal on the 10/100 link.
On The 10/100 link is up but no traffic is passing over the link.
Blinking Indicates the presence of traffic on the 10/100 link.
Gigabit link status
(amber)
a
Off Loss of signal on the Gigabit link.
On The Gigabit link is up but no traffic is passing over the link.
Blinking Indicates the presence of traffic on the Gigabit link.
Alarm (green) Off Normal operation.
On The unit is in an error state. This occurs when the
diagnostics detect a boot failure, a critical error threshold is
exceeded, or a FIPS test fails when the ETEP is in FIPS
mode.
Status (1,2,3,4) Off Unit is up and operational.
On Displays diagnostic codes during boot up.