Filter
Top Products
ET1000A Physical Description
ETEP Installation Guide 15
LED Indicators
The ET1000A LED indicators are shown in Figure 9. The LEDs are described in Table 3.
Figure 9 ET1000A LED Indicators
Table 3 describes how to interpret the LEDs on the ET1000A front panel.
Elements of Figure 9:
1) Power LED
2) Alarm LED
3) Diagnostic display
4) Link indicators: 10/100 Ethernet management port
5) Link indicators: Gigabit management port
6) Link indicators: Aux1, Remote and Local ports
7) Power supply status LEDs
Table 3 ET1000A Front Panel LED Indicators
Indicator Light State Indication
Power (green) Off Unit is powered off.
On Unit is powered on.
Alarm (green) Off Normal operation.
On The unit is in an error state. This occurs when the
diagnostics detect a boot failure, a critical error threshold is
exceeded, or a FIPS test fails when the ETEP is in FIPS
mode.
Diagnostic code display On Displays diagnostic codes during boot up. After boot up, it
reflects the operational state of the appliance and error
conditions.
10/100 link status (green) Off Loss of signal on the 10/100 link.
On The 10/100 link is up but no traffic is passing over the
interface.
Blinking Indicates the presence of traffic on the 10/100 link.
Gigabit link status (green)
a
Off Loss of signal on the Gigabit link.
On The Gigabit link is up but no traffic is passing over the
interface link.
Blinking Indicates the presence of traffic on the Gigabit link.