Filter
Top Products
Installation
36 ETEP Installation Guide
When the appliance powers up, all LEDs illuminate. The power LED remains lit until the unit is powered
off.
During the boot process the ETEP cycles through its startup tests, and the corresponding status LEDs are
illuminated. After the tests execute successfully, the status indicators turn off.
NOTE
During the boot process the ETEP discards all traffic on its data ports. Once the appliance is operational,
the default mode of operation passes all packets in the clear until you deploy security policies.
Installing the ET0100A
To prepare the ET0100A for installation, review the installation steps in Table 14, unpack the shipping
carton, and prepare a space for the installation of the appliance.
The steps to perform for a typical installation are listed below.
Cabling Requirements: ET0100A
Table 15 outlines the standard cables used with each port on the ET0100A. The connector type listed
indicates only what is required to connect to the ET0100A port, and may or may not be the same
connector type required for the other end of the cable. Some cables are supplied by Black Box and others
are user-supplied.
Table 14 ET0100A Installation Steps
Step Action to Perform Description
1 Review the cabling requirements. on page 36
2 Unpack the shipping package. on page 37
3 Prepare a space for installation of the ET0100A. on page 37
4 Connect the cables. on page 38
5 Apply power to the ET0100A. on page 39
Table 15 ET0100A Standard Cables
ET0100A Port Cabling Supplied by...
Power receptacle Power supply cable certified
and approved for use in the
country of interest
Black Box
RS-232 Port Shielded copper null modem
cable, RS-232 DB9 connector
(female to male)
Black Box
10/100 Ethernet Management
Port
Shielded Category 5 straight
through cable (STP), RJ-45
connector
a
Black Box