Filter
Top Products
Initial Setup
60 ETEP Installation Guide
ip <ip address> <subnet mask> [gateway]
After entering the new IP address, it takes 10-20 seconds for the ETEP to set the address on the
management port. During that time you cannot enter any CLI commands. When the operation is
complete, the
man-if> prompt is displayed.
4 Optional. If the ETEP is operating in an IPv6 network you can also assign an IPv6 address to the
management port. To do so, type
ip6 {<ip address>/<prefix-length>} [gateway]
5 Auto-negotiation is enabled by default. If you want to disable auto-negotiation and manually set the
link speed and flow control, configure the autoneg command. Attributes are described in Table 22.
autoneg {on} | {off [<speed>] [<flow-control>]}
6Type exit to return to the config prompt, or type top to return to the command prompt.
ip address Management port IP address, entered in dotted decimal notation.
subnet mask IP subnet mask, entered in dotted decimal notation.
gateway Specifies how to route traffic between the ETEP management port and the
management station. When the management port is on a different subnet than
the management station, specify the IP address of the router’s local port on
the same subnet as the ETEP management port (see Figure 42). If the
devices are on the same subnet, you do not need to enter a default gateway.
ip address IPv6 address of the ETEP management port. This is a 128-bit address
consisting of eight hexadecimal groups that are separated by colons. Each
group is a 4-digit hexadecimal number. The hexadecimal letters in IPv6
addresses are not case sensitive.
prefix-length A decimal value that indicates the number of contiguous, higher-order bits of
the address that make up the network portion of the address. The decimal
value is preceded by a forward slash (/).
gateway IPv6 address of the router port that is on the same local network as the ETEP
management port.
Table 22 Management port autoneg command description
Attribute Description
on Enables auto-negotiation on the management port. This is the default
setting.
off Disables auto-negotiation on the management port. Use this setting to
manually configure link speed and flow control.
speed [10m | 100m | 1000m]
When auto-negotiation is disabled, the speed attribute specifies the link
speed. The speed defaults to 100m.
duplex [half/full]
When auto-negotiation is disabled, the duplex attribute specifies the duplex
setting. The duplex setting defaults to full.
flow control [on | off]
When auto-negotiation is disabled, this attribute configures the flow control
setting to be on or off. The flow control setting defaults to on.