Filter
Top Products
23
aCHAPTER 4: Installation and ConfigurationCHAPTER
Figure 4-2. The LED connection.
9. Most PCI-bus computers will automatically assign the Adapter an I/O address,
IRQ channel, and BIOS address. If this is not the case with your system, you’ll
have to do this manually, either by setting jumpers on the PC’s motherboard
(which you can do now; refer to your PC’s documentation) or changing the
settings of the PC’s CMOS BIOS (you’ll have to do this later—see
Section 4.3). (If the PC will be booting from a SCSI drive attached to the
Adapter, you might also need to change the drive-type setting in the PC’s
BIOS, because it might be expecting the boot drive to be an IDE drive.)
10. If you are attaching any internal SCSI devices to the Adapter, go on to
Section 4.2. Otherwise, replace the PC’s cover, reconnect all devices,
plug the PC back in, and go on to Section 4.3.
1
1
Cable from
Motherboard’s
Hard-Drive-
Activity LED
J3: LED
Connector