Filter
Top Products
46
ULTRA2 LVD SCSI HOST ADAPTER
9. We highly recommend that you verify that your Windows 95 device driver has
been properly installed by starting at the desktop and selecting these items
one after the other (each item contains the next in sequence): “My
Computer,” “Control Panel,” “System,” “Device Manager” tab, “SCSI
Controllers” category, “Initio INI-A100U2W PCI SCSI Controller.” If “This
device is working properly” is displayed on your screen, the driver has been
correctly installed.
5.2.2 A
DDING THE
W
INDOWS
95 D
RIVER TO AN
E
XISTING
W
INDOWS
95/95
A
S
YSTEM
These instructions will guide you through the installation of the
Ultra2 LVD SCSI
Host Adapter
’s Windows 95 driver in an existing Windows 95 or 95a system.
Windows 95 will automatically detect the presence of new hardware in Plug-and-
Play compliant systems. It is important to make sure that the Adapter hardware has
been properly installed before proceeding further.
1. Reboot the system. Microsoft Windows 95 will detect the presence of new
hardware at bootup and will display a dialog window titled “New Hardware
Found”; “PCI SCSI Bus Controllers” will be highlighted.
2. Select “Driver from Disk Provided by Hardware Manufacturer,” then “OK”.
3. Select “SCSI Controller” from the list of available devices, then select “Have
Disk...”
4. When the “Install from Disk” window is displayed, insert Driver Disk 1 into
drive A:, then enter the pathname of the Windows 95 driver’s directory
(“A:\WIN95”) and select “OK”.
5. Select “Initio INI-A100U2W PCI SCSI Controller”, select “OK”, then “OK”
again to install the INIA100.MPD driver on your hard-disk drive. (Because of
a Windows quirk, the A:\WIN95 directory might become deselected; it might
be necessary to direct Windows back to A:\WIN95—possibly several times—
before it actually copies the driver.)
6. This completes installing the Adapter’s device driver. Reboot the system to
activate the driver.
7. We highly recommend that you verify that your Windows 95 device driver has
been properly installed by starting at the desktop and selecting these items
one after the other (each item contains the next in sequence): “My
Computer,” “Control Panel,” “System,” “Device Manager” tab, “SCSI
Controllers” category, “Initio INI-A100U2W PCI SCSI Controller.” If “This
device is working properly” is displayed on your screen, the driver has been
correctly installed.