Filter
Top Products
69
CHAPTER 5: Driver Installation
5.6.2 A
DDING THE
OS/2 D
RIVER TO AN
E
XISTING
OS/2 S
YSTEM
For computer systems using other SCSI host adapters or an IDE device to provide
the system boot routines, these instructions will guide you through
Ultra2 LVD
SCSI Host Adapter
driver installation. The OS/2 driver is on Driver Disk 1. It is
important that the SCSI hardware and OS/2 opertaing system be installed
correctly before proceeding further.
1. Once an OS/2 session is established, insert Driver Disk 1 into your floppy
drive.
2. By using your installed mouse, or by using the appropriate keystrokes, select
“Device Driver Install” from the “System Setup” group.
3. Select “Change”. Select “OS2” and select “Set”.
4. Select “Destination Directory”. Either accept the default destination directory
or select “Change” to make any existing OS/2 directory the destination
directory. Select “Set”.
5. Select “Install” from the “Device Driver Installation” group. Select “Initio
INI-A100U2W Device Driver for OS/2”. Select “OK”.
6. Select “Exit” to install the OS/2 device driver. Exit and reboot the system to
activate the driver.