Filter
Top Products
74
ULTRA2 LVD SCSI HOST ADAPTER
5.8.1 I
NSTALLING THE
D
RIVER IN A
N
EW
SCO UNIX S
YSTEM
Take these steps to install the
Ultra2 LVD SCSI Host Adapter
driver along with your
new SCO UNIX operating system:
1. Insert the SCO UNIX N1 boot disk into the floppy drive and turn on the
system. At the SCO UNIX boot prompt, type “link <ENTER>”.
2. The system will ask you what packages you want linked to the system; type
“a10 <ENTER>”. The system at this point will boot into SCO UNIX. Please
refer to the SCO UNIX Documentation for additional information. When
prompted by the installation routine, insert Driver Disk 2 diskette in your
floppy drive and press <ENTER>.
3. Please refer to the SCO UNIX Documentation for additional information.
You have completed the installation of the Adapter driver for SCO UNIX.
5.8.2 A
DDING THE
D
RIVER TO AN
E
XISTING
SCO UNIX S
YSTEM
(A
DAPTER
N
OT
B
OOTABLE
)
Take these steps to install the
Ultra2 LVD SCSI Host Adapter
driver in an existing
SCO UNIX system without making the Adapter you just installed a bootable adapter:
1. Insert Driver Disk 2 in your floppy drive.
2. Type: “installpkg <ENTER>” at the command prompt.
3.
The system will ask you what packages you wish to install. Type: “a10 <ENTER>”.
4. Type these lines to change the directory and rebuild the UNIX kernel:
cd /etc/conf/cf.d <ENTER>
. /link_unix <ENTER>
5. You have completed the link procedure for the Adapter driver. Exit and
reboot the system.