Cabletron Systems 6H128-08 Switch User Manual


 
Chapter 5: Local Management
5-60 6H128-08 and 6H129-08 User’s Guide
5.17 SNMP TRAPS SCREEN
Since the 6H12X-08 is an SNMP compliant device, it can send messages
to multiple Network Management Stations to alert users of status
changes. The SNMP Traps screen is shown in Figure 5-23.
Access the SNMP Traps screen from the Module Configuration Menu
screen by using the arrow keys to highlight the SNMP TRAPS menu item
and pressing ENTER. The SNMP Traps screen displays.
Figure 5-23 SNMP Traps Screen
The following explains each field of the SNMP Traps screen.
Trap Destination (Modifiable)
Indicates the IP address of the workstation to receive trap alarms. Up to
eight different destinations can be defined.
NOTE
It is only necessary to assign SNMP traps if the user desires
the traps to be sent to different addresses than those assigned
in Section 5.9, which details how to set SNMP Traps for the
6C105 chassis.
Firmware Revision: XX.XX.XX
SNMP Traps
2159-18
BOOTPROM Revision: XX.XX.XX
Trap Community Name
public
public
public
public
public
public
public
Module Type: 6H128-08
Slot Number:
X
EXIT
6H128-08 LOCAL MANAGEMENT
Event Message Line
RETURNSAVE
Trap Destination
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
Enable Traps
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]