Filter
Top Products
Connecting to the Network
6H128-08 and 6H129-08 User’s Guide 3-11
2. Insert one end of the SC connector into the FE-100FX or FE-100F3
installed in the 6H12X-08 module. See Figure 3-5.
3. At the other end of the fiber optic cable, attach the SC connector to the
other device.
Figure 3-5 FE-100FX and FE-100F3 Port Connection
4. Verify that a link exists by checking that the port RX LED is on
(flashing amber, blinking green, or solid green). If the RX LED is off
and the TX LED is not blinking amber, perform the following steps
until it is on:
!
CAUTION
Do not touch the ends of the fiber optic strands, and do not let
the ends come in contact with dust, dirt, or other contaminants.
Contamination of the ends causes problems in data
transmissions. If the ends become contaminated, blow the
surface clean with a canned duster. A fiber port cleaning swab
saturated with optical-grade isopropyl alcohol may also be used
to clean the ends.
NOTE
During the bootup process, the RX LED flashes green and
amber, and will not indicate if a link exists until bootup is
complete.
2159-06
7
8
RX LED
TX LED
RX LED
TX LED
SC Connector
Fiber Port