Filter
Top Products
Collating Copies
1-39
Basic Copying Features
1
Collating Copies
The Finisher modes can be selected to collate the copies in various ways, either by
pages or copy sets.
■ The table below shows all the finishing modes that are available with each
different optional unit, and the paper sizes that can be used.
✔ : Available
—: Unavailable
*1 The copies are stapled at the part that represents the upper left corner of the original.
*2 The maximum when you are using 17 lb bond to 20 lb bond (64 g/m
2
to 80 g/m
2
) paper. If the number of sheets
is greater than the limit, they will not be stapled.
IMPORTANT
Pull out the output auxiliary tray when stapling paper larger than 11"
×
17" or LGL.
NOTE
If <AUTO COLLATE> is set to ‘COLLATE’ or ‘STAPLE’, the Collate (Offset Collate with
the optional Finisher-U1 attached) or Staple mode is automatically set when you place
the originals into the feeder. (See “Auto Collate,” on p. 3-14.)
Optional Unit Collate Offset Staple*
1
None
✔
11" × 17", LGL, LTR,
LTRR
——
Finisher-U1 —
✔
11" × 17", LGL, LTR,
LTRR
✔
11" × 17", LGL,
LTRR (30 sheets)*
2
,
LTR (50 sheets)*
2
Inner 2 Way
Tray- E1
✔
11" × 17", LGL, LTR,
LTRR
——