Filter
Top Products
Report and List Samples
9-4
9
Appendix
Multiple Communication Result Report
This report is used to check whether documents were sent successfully to the
intended destinations when a sequential broadcast transmission was performed.
You can set whether to automatically print a Multiple Communication Result Report
after sending documents. (See "TX Report," on p. 7-3.)
NOTE
•
You can also print a Multi TX/RX Report with an image of the sent original attached to it.
(See "TX Report," on p. 7-3.)
•
The default setting is 'For Error Only'.
■ JOB NO.
The four digit number, that is automatically assigned when the document is accepted for
sending, is printed.
■ DEPT. ID
If Department ID Management is set, the Department ID is printed.
■ PGS.
The number of pages that were sent successfully to the destinations is printed.
■ TX/RX INCOMPLETE
If a transmission is incomplete, the fax number and the name of the destination are
printed. If there is no applicable destination, "_ _ _" is printed.
■ TRANSACTION OK
The fax number and the name of the destination of a completed transmission are printed.
If there is no applicable destination, "_ _ _" is printed.
■ ERROR
If an error in transmission occurs, the fax number and the name of the destination are
printed. If there is no error, "_ _ _" is printed.