Filter
Top Products
40
Selecting a Job and Scanning
1
Place the document in the scanner. (See p. 26)
The top screen of Select Scan Job appears.
2
Click a job.
Hint
• If you set [Check output after scanning] to [ON], you can check
the output settings after scanning.
• If you set [Enable continuous scanning] to [ON], you can
continue scanning after all the pages of the document are
scanned.
3
Click the Start button.
The document is scanned. While scanning is in progress, the
number of pages scanned is displayed in addition to the scanner
settings.
When all the pages of the document are scanned, the scanned
images are output according to the registered job settings and the
complete screen appears.
IMPORTANT
If you configure scanning conditions that consume a large amount of
the computer’s memory, scanning may stop because of insufficient
memory. If an error message appears due to insufficient memory
while scanning is in progress, exit the application, change the
scanning conditions, and then try scanning again.